3.0 LITER. A Bolt used to attach the Drive Motor Battery Pack Charger to its mounting point. A Bolt used to secure the automatic transmission Oil cooler control valve to its mounting point. A fastener which secures the Liftgate Bumper to it's mounting point. A rubber ring with a hole in the center which provides protection through which another component can pass through. A screw used to secure the Suspension Control Arm to its mounting surface. A threaded rod with a Drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Air Injection System Line to it's mounting point. A threaded rod with a Drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Automatic Trans Shift Cable to it's mounting point. A threaded rod with a Drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Liftgate Wedge to it's mounting point. A threaded rod with a Drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Radiator Support Panel Reinforcement to a mounting point. A/C ExPansion Valve Bolt. Accessory Drive Belt Idler Pulley Bolt. Automatic Transmission Oil Cooler Bolt. Automatic Transmission Oil Cooler Hose Banjo Bolt. Bolt for the brackets that hold the Radiator Hose. Bolt hat secures the Air Bag Impact Sensor. Door Mirror Housing Bolt. Engine Camshaft Position Sensor Bolt. Engine Coolant Pipe Bolt. Engine Coolant Thermostat Housing Bolt. Engine Oil Cooler Bolt. Engine Water Pump Bolt. Exhaust Gas Recirculation (EGR) Valve Bolt. Fastens the dipstick Tube to the Engine. Part cannot be reused/reinstalled. Part inclued with Water Pump assembly. Secondary Air Injection Pump Bolt. TurboCharger Oil Line Bolt. Included with: Battery Charger, Charging port, Cylinder head, Housing assembly, TurboCharger, Water Pump, Water Pump assembly.